Available Rentals
QUERY_STRING:action=category&num=23445
URL:/equipment.asp
BrowsingRentalType:Party
URL:/equipment.asp
BrowsingRentalType:Party
TRAILERS & TRAILER ACCESSORIES
MOTORIZED SCOOTER- HITCH MOUNTED CARRIER
Product Information
- Universal design can be used with most power wheelchairs and scooters
- Integrated solid ramp for quick loading and unloading
- Quick action spring pull pins secure the ramp for transport in the folded flat or vertical positions
- Carrier can be folded up flat vertically against the rear of the vehicle saving space when not in use
- Tough black powder coating protects against dust, dirt, & debris from the road
- Tested 400 lb weight capacity
- Rack weighs only 65 lbs
- Steel expanded mesh surface with raised 3-1/8" side rails
- 11 total tie down points (tie-down straps not included)
- Quick and easy 5 bolt assembly
- Includes an anti-tilt locking device to prevent the rack from wobbling
- 2 small rear reflectors included for added visibility when using at night
- For use with 2" Class III or IV trailer hitches
- Not for use with 1-1/4" hitches
- Warning and Usage Guidelines
- Carrier Carrying Capacity: The SC400 carrier is designed to safely carry 400 lbs
- Hitch Weigh Limit: Most Class III hitches are rated for 500 lbs - Most Class IV hitches are rated for 1,000 lbs
- Vehicle Hauling Capacity: Your hauling weight may be limited by your vehicle's capacity to carry a load
- Will not work with Class II or smaller receivers
- Some vehicles may require air shocks or heavier springs to stiffen up the suspension to prevent sagging
- Please check with your dealer to find out your vehicle's carrying capacity
- NOT recommended for tow-behind trailers including 5th wheel trailers and camping trailers
- NOT recommended for use with hitch adapters/extensions
- NOT designed to carry scooter or wheelchair while occupied
- Maximum scooter or wheelchair width is 27" wide
- 1. SLIDE ANTI-TILT LOCKING DEVICE TIGHT UP AGAINST HITCH RECEIVER, INSERT HITCH PIN OR PINCH BOLT AND TIGHTEN BOLTS USING 17MM WRENCH.
- 2. INSERT CARRIER INTO HITCH AND INSTALL THE PINCH-BOLT ASSEMBLY. (BOLT-> SLEEVE-> HITCH-TUBE -> WASHER-> NUT)
- 3. TIGHTEN HEX HEAD PIVOT BOLT WITH 10mm ALLEN WRENCH TO ELIMINATE SIDE TO SIDE WOBBLE OF THE HITCH CARRIER. DO NOT OVER-TIGHTEN. IF BOLT IS OVER-TIGHTENED CARRIER WILL NOT BE ABLE TO PIVOT OR SWING UP.
- 4. ADJUST LEVELER BOLT TO ALIGN PIN HOLES. PIN SHOULD BE ABLE TO BE REMOVED/ INSTALLED WITHOUT BINDING IF PROPERLY ADJUSTED. TIGHTEN JAM NUTS WHEN PROPERLY ALIGNED USING 17mm OR 11/16" WRENCH.
- 5. REMOVE PIN TO FOLD CARRIER VERTICAL. REPLACE PIN IN TOP PIN HOLE TO SECURE CARRIER IN THE VERTICAL POSITION.
Model: | SC400-V2 |
---|---|
Daily: | $53.00 |
Weekly: | $161.00 |
* Prices are subject to change. Tax and other fees not shown in above price estimate.
Last Update: 6/21/2025 6:24:05 AM
Call For Tools, Job Site, & Equipment Rental
Call For Party & Event Rentals